An Ulano abrasive degreaser gel that combines the actions of Microgrit No. 2 and Screen Degreaser Liquid No. 3. The abrading action of Ulanogel 23 promotes better wetting of the mesh and adhesion of the stencil, and thus, longer press life. Its degreasing action removes dirt, dust, and oils from the mesh, reducing the risk of stencil failure and pinholing. Ulanogel 23 is ready-to-use and rinses off in hot or cold water. Its thixotropic character permits easy and effective preparation of larger screens held in a vertical position. Non-caustic - will not harm frames, mesh, or adhesives on stretch and glue frames. Recommended for use with all stencil systems on synthetic mesh only. INSTRUCTIONS STEP 1: Dampen the screen mesh with water. STEP 2: Apply Ulanogel 23 to both sides of the screen and scrub vigorously with a wet, stiff, short-bristle nylon brush on both sides of the mesh. STEP 3: Rinse the screen throroughly from both sides, including the inside edge of the frame and the frame corners, with hot or cold water.