These100% solids plastisol inks can be used for direct printing, cold-peel transfers, hot-peel transfers (with the addition of 500 Quick-Trans Additive) and as a flock adhesive. They are available in more than 40 standard colors, including 15 premixed metallics and glitters. A litho backing white is also available.

RECOMMENDED FABRICS
Cotton and some cotton/polyester blends. Always test print fabric before beginning a production run. Test for bleed resistance .
INK APPLICATION

• Direct Prints: For softer feeling direct prints, add 5% to 25% by vol- ume, of 710LF Softhand Additive. Reducing the ink with 1110LF Curable Reducer and using finer meshes can also greatly improve the softness of the finished print.

• Transfers (cold peel): It is important that the inks are only gelled dur- ing the transfer printing process otherwise the inks will not have adequate adhesion during the final transfer application.
  
• Transfers (hot peel): Mix inks with 500 Quick-Trans Additive and printed on a hot peel release paper. Gelation temperatures are the same as cold peel transfers. This procedure is not recommended for the glitter inks or metallic inks.

TRANSFER APPLICATION
Cold peel transfers: 10 to 15 seconds @ 350°F to 375°F (177°C to 191°C). Medium pressure (40 Ibs.) Hot peel transfers: 3 to 7 seconds @ 375°F to 400°F (191°C to 204° C). Medium to heavy pressure (40 lbs. to 60 lbs.)
SCREEN MESH

• 60 - 305 t/in  Monofilament for direct prints or transfers.
•  60 t/in  Monofilament for 155LF LB Shimmer
•  95 - 125 t/in  Monofilament for metallic colors
• 16T - 25T t/in  Monofilament for glitter inks

SQUEEGEE
65-70 Durometer: Sharp or beveled edge.
CURE TEMPERATURE
Direct prints: 325°F (163°C) Entire ink film. Transfers: Gelation 225°F to 260°F (107°C to 127°C). Test dryer temperatures before a production run. Wash test printed product before beginning production run.
CLEAN-UP
Mineral spirits or any environmentally friendly plastisol screen wash.
STORAGE OF INK   
Recommend storage at 65°F to 90°F (18°C to 32°C). Avoid storage in
direct sunlight and moist, humid air.
MODIFYING INK
If reduction in viscosity is needed in inks, use 3% to 20% by volume, of 1110LF Curable Reducer. A mixture of 1 part 710LF Softhand Additive to 4 parts 1110LF Curable Reducer, added in the same proportion as 1110LF, will result in a product that will reduce, soften, and de-tackify plastisol inks for wet on wet printing. Adding too much reducer and/or additive will reduce opacity of inks.