SUMMARY:

•  Ready for use, High Performance plastisol formulated for Ultra High speed automatic printing.
•  Very creamy and short bodied, with low tack and for ease of printing, a greatly improved shear.
•  Well suited for high definition and resolution, fine detail and halftone printing.
•  Faster production speeds with less pressure. Can be printed through finer mesh counts for faster production speeds with less pressure.

RECOMMENDED FABRICS
Light colored 100% cotton or cotton/polyester blends. Use an underbase for printing dark fabrics.
INK APPLICATION
Colors should be printed without any modifications. If thinning is required, use 1099LF LB Lo-Bleed Reducer (1% to 3% by weight).
SCREEN MESH AND EMULSION
110 to 305 t/in 43 to 120 t/cm Monofilament
Any direct or indirect lacquer resistant emulsion. Use 35 to 70 micron capillary film for best results.
SQUEEGEE
60-70 Durometer: Sharp Edge 60-90-60 or 70-90-70 Triple Durometer: Sharp Edge
CURE TEMPERATURE
325° (163°C) Entire ink film. Test dryer temperatures and wash test printed product before and during a production run.
CLEAN-UP
Mineral spirits or environmentally friendly McLogan Textile Press Wash.
STORAGE OF INK
Recommend storage at 65°F to 90°F (18°C to 32°C). Avoid storage in CONTAINERS    direct sunlight. Keep containers well sealed.

IMPORTANT INFORMATION
1. Use an underbase print when printing 7600 inks onto dark fabrics. Use  7031LF white as an underbase ink. To achieve a softer hand and faster production speeds, print underbase ink through finer mesh counts 230 to 305 t/in
2. The 7600 inks are low bleed inks, not non-bleed inks. On some types of fabric, bleeding or dye migration may occur. Always test print the fabric to be printed before beginning production. Bleeding or dye migration may not occur right away.

ONE GALLON CONTAINERS