SUMMARY:

Very durable, high-viscosity plastisols formulated for printing directly on most athletic garments,1100 Series inks also can be used for cold-peel transfers and as a flock adhesive. Available colors match the most popular colors used for athletic garment printing.

RECOMMENDED FABRICS
Nylon mesh, cotton, and some cotton/polyester blends. Always test print fabric before beginning a production run for adhesion and possible dye migration. 1100 Series plastisols are not low bleed inks. Testing is required for bleed resistance on cotton/polyester blends.
INK APPLICATION
The 1100 series inks can be printed directly from the container or for greater durability and adhesion on problem fabrics (micro-mesh), mix with the 900LF Catalyst. In general, if the ink can surround the fiber of the fabric being printed, the use of 900LF Catalyst may not be necessary. Catalyst must be purchased separately if needed. 900LF Catalyst is available in 2 oz. and 8 oz. containers and when used should be throughly hand stirred into the ink to the following proportions:
By volume = 16 parts ink to 1 part catalyst By weight    = 20 parts ink to 1 part catalyst
1 oz. Catalyst to 1 pint of ink 2 oz. Catalyst to 1 quart of ink 8 oz. Catalyst to 1 gallon of ink
Ink may be used immediately after mixing. Do not mix more ink than is needed for a job. Do not under catalyze the ink. Pot life of mixed ink is 4 to 8 hours. Over catalyzation will shorten pot life of ink.
900LF Catalyst must be purchased separately.
SCREEN MESH
60-160 t/in or 24-63 t/cm Monofilament
SQUEEGEE
75-70 Durometer: Bevel or sharp edge
CURE TEMPERATURE
325°F (163°C) Entire ink film. Test dryer temperatures before a production run. Wash test printed product before beginning production run.
CLEAN-UP
Mineral spirits or environmentally friendly McLogan Textile Press Wash.
STORAGE OF INK   
Recommend storage at 65°F to 90°F (18°C to 32°C). Avoid storage in CONTAINERS    direct sunlight and moist, humid air.